Z-Wave Network Exclude – v2

Contents

Follow the directions for your Z-Wave hub/controller to place it in the exclusion mode.
Press the iblinds motor inclusion button (IN/EX) or the Charge Adapter button ONE (1) time and wait for the iblinds device to be removed from the Z-Wave network.

Note: If you are having trouble after following these steps, please check the Inclusion/Exclusion link to troubleshooting page.

Hubitat

Choose the Discover Devices link on your Hubitat Web Interface home page or from the menu at the top right
Select “Z-Wave”
Select “Start Z-Wave Exclusion”
Press the IN/EX button on either the iblinds device or the charge adapter ONE (1) time

In the web interface, open the PLUG-INS drop menu, then Z-Wave, then click on Controller Management
Locate the Z-Wave Interfaces area and expand your Z-Wave Controller section. Open the Actions menu and choose Remove/Exclude a Node
Click the Start button. Your Z-Wave Interface is now in Removal mode and is ready to communicate with your device
Press the IN/EX button on either the Charge Adapter or iblinds ONE (1) time. When done, you’ll receive an acknowledgment such as “DONE – Remove Node Operation is Complete.” Your Z-Wave device is now removed from your Z-Wave network

From the Home screen, select Menu (=) and touch Devices
Select the SmartThings Hub
1. If you have SmartThings Wifi, select your Wifi Hub and then Use SmartThings Hub
Touch More Options (:) and select Z-Wave utilities
Touch Z-Wave exclusion
Press the IN/EX button on either the Charge Adapter or the device itself, ONE (1) time
The app will indicate when the device is successfully removed. Tap Done

Select the Device you wish to remove from your hub.
Touch Delete
On the next screen, touch Unpair. Only press Delete when the device is no longer working
When prompted, press the IN/EX button ONE (1) time
This may take up to 5 minutes to remove using the mobile app